Jedi Ranger's Lightsaber Holster v2.0

Finally, I have created a lightsaber thigh holster that is truly one-handed, and in leather....finally!!  It went through several revisions on paper, before I finally began fabrication.  Once the initial version was done, I was able to put it through a 4-hour "test", at a halloween event.  One point/feature/location that I feared would cause problems, did.  Before the event, I already had a few ideas on how to remedy the possible problem, and I didn't use any of them.  I later found a piece of stainless steel that now does the job perfectly, after going through 12, yes 12, Dremel cutting discs.  I also finally used 2 of my sweet nickel-plated metal side-release buckles.

This design is compatible with any and all lightsaber hilts (except curved and very short hilts) that use the now-common and popular covertec knob, including most Master Replicas.

Additional references: